Purpose: The purpose of this lab is to prove that the quickening of staidness is 9.8m/s/s. We did this by taking a time go under photo of a clump dropped with a meter exhaust neighboring to it. While the ball was dropped, a stroboscope arc was trice 3000 times per second, which created measurable points of the balls descent. Then we did a few polar interprets of the information points by hand and computer. Procedure: 1. localize up a meter stick vertically against a black reason 2. Set up a strobe light to flash against this background at 3000 times per second. 3. focus on a camera to espouse in the entire duration of the meter stick to jibe that the balls entire flight is captured. 4. recrudesce out back the slide to restore the film. 5. Press and hold the shut open and drop the ball at the same time. 6. waiver the shutter when the ball hits the ground. 7. deferment 30 sec for the figure to develop and record the measurements for each(p renominal) time the ball is shown. 8. Set up a graphical record with time as the x-axis and your standoffishness measurements on the y-axis. 9. while your distance points each .02s, then sketch a best satisfy curve. 10. mark off the slope at every other entropy point by drawing tan lines. 11. The slope set up on the tangent lines is the focal ratio at each instance. 12. Plot a new graph using the velocity data as the new y-axis. 13. Determine the slope of that graph to come across the experimental acceleration 14. Repeat process on computer.
Data: Distance vs. beat Distance(cm) Â Â Â Â Â Â Â Â Time(s) 0 Â Â Â Â Â Â Â Â 0 3! .5 Â Â Â Â Â Â Â Â .02 7.5 Â Â Â Â Â Â Â Â .04 11.5 Â Â Â Â Â Â Â Â .06 16.5 Â Â Â Â Â Â Â Â .08 21.5 Â Â Â Â Â Â Â Â .10 27.5 Â Â Â Â Â Â Â Â .12 33.5 Â Â Â Â Â Â Â Â .14 40.5 Â Â Â Â Â Â Â Â .16 46.5 Â Â Â Â Â Â Â Â .18 54.5 Â Â Â Â Â Â Â Â .20 62.5 Â Â Â Â Â Â Â Â .22 Slopes of Distance vs. Time (change... If you indispensableness to get a full essay, order it on our website: OrderCustomPaper.com
If you want to get a full essay, visit our page: write my paper
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.